Autonomic, Mirage Media Server, Mirage, MMS, MMS-5, MMS-2, MMS-5A, MMS5, MMS2, MMS5A

Register

M⋅401e, Multi-Room Digital Amplifier

Purchasing
The Mirage M-401e Multi-Room Digital Amplifier is a state-of-the-art, IP controllable, multi-room amplifier with some of the highest performance specifications in its class. Boasting 50 watts per channel into an 8-ohm load, the M-401e has the power to drive higher end architectural or floor-standing speakers. Its IP controllability makes it the perfect choice in a controlled environment, and coax and TOSLINK digital connectors on all inputs ensure clean and pure sonic performance in every room.

Use it as a stand-alone, IP-controllable distribution amplifier, or pair it with a Mirage Media Server to create a complete whole home audio solution, the Mirage Audio System. The Mirage M-401e is a 4-zone amplifier, expandable to 96 zones, with extensive zone linking capabilities.

Remotely manage and access the web configuration of the Mirage M-401e Multi-Room Amplifier using the Autonomic Dealer Zone Device Manager (available only to authorized Autonomic Dealers).
Multi-Zone, Multi-Source Switching The M-401e amplifier can route audio signals from any one of its 6 inputs (analog or digital) into any one or more of its 4 amplified zone outputs under manual or with IP or RS-232 automation control.
Control and Configuration Built in web interface
Zone Linking A zone group can be created to link multiple zones. Zone linking ties the source selection together across the group. It can optionally coordinate volume and the power state of linked zones. This is useful for closely coupled audio areas where it is advantageous to separate volume levels, but the same audio source, or coordinate the same volume with separate power control.
Expandable to 96 Zones The four-zone M-401e can be configured in a stack of up to 12 amplifiers (M-401e or M-801e models) and operate under a unified control interface to accommodate large installations without the complexity of coordinating the control of multiple amplifiers.
M-401e rear panel
Front Panel Solid Aluminum
External Controls and Indicators Infrared receiver; front blue light when power is supplied
Mounting (2) rack ears included; (4) adhesive rubber feet included
Rated Output Power (FTC)
All Channels
55W per channel / 8Ω loads
75W per channel / 4Ω loads
Total Harmonic Distortion (THD) 0.1% (50 Watt, 8Ω load)
Damping Factor (8Ω load) 10
Speaker Impedance (Z1-Z6 L/R) 4Ω - 8Ω
Analog Input Sensitivity (S1-S8 L/R) 0.75V RMS (Vol 100, Gain 0dB, 55W Output)
Analog Input Impedance (S1-S8 L/R) 22KΩ
Digital Input Sensitivity 0dBFS
Frequency Response 48 KHz sample rate: 10Hz - 22 KHz
96 KHz sample rate: 10Hz - 42 KHz
Tone Control ±12dB, 100Hz (Bass)
±12dB, 10kHz (Treble)
Signal-to-Noise Ratio 95dB (IHA-A, 0.75V input / unbalanced)
IR Output (6) 3.5mm Jack: IR1 - IR8 current limited to 25mA
Source Inputs (6) Digital Coaxial RCA, (4) Analog (L/R) RCA, (2) TOSLINK
Ethernet (2) 100Base-T, MAIN IN and Switch EXT OUT
USB (1) USB mini-B female 5-pin
Data (1) 4 pole 3.5 mm terminal block connector (Data,12V, IR,0V)
Controllers (4) RJ45 sockets Keypad controller ports
BUS RUN (1) 4-way terminal block (0V, IR 12V and Data)
Amp On and PG Control (1) 8 way terminal plug with Amp ON 1-8 and (2) page preset contact closure inputs: PG1 and PG2
Zone Triggers and Presets (1) 8 pole 3.5 mm terminal block connector (Zone trigger 0V out, Zone trigger 1-8 12V out, Common, Preset 1-2 in)
Power Supply 110–240V AC 50–60Hz
Power Consumption 650W (6W on standby)
Dimensions, with feet attached
Height, without feet
4.0" H x 17" W x 15" D (10.2cm x 43.2cm x 38.1cm)
3.5" H (8.9cm); fits 2RU
Weight 15.4 lb. (7 kg)
Zones (4) zones; expandable to 96 zones by attaching additional
M-401e or M-801e amplifiers